Guide des tailles

Origine Paris · Rings, bracelets and bangles

Size
guide

Size 52 52 millimetres of inner circumference. In France, a ring’s size is its inner circumference, measured in millimetres. Nothing else.

Three ways to find your size

At 21 rue de la Paix

The most reliable

We welcome you by appointment to take your size with the workshop ring gauge, try on the models and match the choice to the shape of your hand. A band’s width, a pronounced knuckle, a right hand rather than a left: such details take minutes to see and are hard to guess from afar.

From a ring you own

Printable ring sizer

Take a ring you already wear, on the relevant finger and hand, preferably a thin band. Place it over the circles on the sheet below until the line sits exactly along the inner edge of the ring.

From your finger

Cut-out tape

Wrap the tape below, or a simple strip of paper marked at the point of overlap, around the base of the finger. The length you obtain, in millimetres, is directly your French size.

Print the sheet

Before printing · true scale required

  1. Print at 100%: turn off “Fit to page” and any automatic scaling.
  2. Check the ruler below against a real one: it must measure exactly 10 cm.
  3. If it does not measure 10 cm, do not use the sheet: a print reduced by 4% shifts the reading by a full size.
Scale check
012345678910 exactly 10 cm, ruler in hand
Ring sizer · sizes 42 to 58 · diameters in millimetres
42Ø 13.443Ø 13.744Ø 14.045Ø 14.346Ø 14.647Ø 15.048Ø 15.349Ø 15.650Ø 15.951Ø 16.252Ø 16.653Ø 16.954Ø 17.255Ø 17.556Ø 17.857Ø 18.158Ø 18.5
  1. Lay your ring flat on a circle; the printed line must stay visible all the way round.
  2. The right circle is the one whose line follows the inner edge of the band exactly, without slipping beneath it.
  3. If the line disappears behind the metal, the circle is too large: step back to the previous one.
  4. Between two circles, keep the larger.
Measuring tape · cut out
ORIGINE PARIS 4045505560

The gold line marks zero: the graduation that meets it gives the finger’s circumference, and therefore the size.

  1. Cut the tape along the dotted lines, then slit the black slot.
  2. Wrap it around the base of the finger and slide the tip through the slot.
  3. Pull snug without compressing the skin: the tape should be able to turn, not slide.
  4. Read the graduation at the edge of the slot. That is your size.

Ring size conversion table

Sizes offered online for our rings and wedding bands. Sizes 42 to 48.5 concern the Daisy signet ring and made-to-measure pieces.

FR · DE sizeUSAUKInner Ø · SECircumference
422 ¼13.442
42.52 ¼E13.542.5
432 ½E13.743
43.52 ¾13.843.5
443F14.044
44.5314.244.5
453 ¼G14.345
45.53 ½G14.545.5
463 ¾14.646
46.54H14.846.5
47415.047
47.54 ¼I15.147.5
484 ½I15.348
48.54 ¾15.448.5
495J15.649
49.5515.849.5
505 ¼K15.950
50.55 ½K16.150.5
515 ¾16.251
51.55 ¾L16.451.5
52616.652
52.56 ¼M16.752.5
536 ½M16.953
53.56 ¾17.053.5
546 ¾N17.254
54.5717.354.5
557 ¼O17.555
55.57 ½O17.755.5
567 ½17.856
56.57 ¾P18.056.5
57818.157
57.58 ¼Q18.357.5
588 ½Q18.558

The German size is identical to the French size: both denote the inner circumference in millimetres, so a German 54 is a French 54. The Swedish size is the inner diameter in millimetres, read in the Ø column; storlek 17 thus corresponds to our size 53.5. American and British sizes are approximate equivalences, to the nearest quarter size for the USA and half letter for the UK; the millimetre measurement prevails. Between two rows, or when the same USA or UK size appears on two rows, keep the larger. Diameters rounded to a tenth of a millimetre.

Advice from the workshop

  • Measure at the end of the day, at room temperature. Fingers are slimmer in the morning and in cold weather; a size taken then often proves too tight in summer.
  • Between two sizes, choose the larger. A ring should pass the knuckle without effort and come off without forcing.
  • A wide band wears half a size up. The more generous the band, the more of the finger it covers: allow an extra half size beyond three millimetres of width.
  • Measure the finger that will wear the ring. The ring finger of the dominant hand is almost always slightly larger than the other.
  • If in doubt, an adjustment remains possible. Our workshops resize your piece after purchase.

Bracelets and bangles

Size is not read the same way for every construction. A clasped rigid bracelet is chosen by wrist circumference. An open bangle is chosen by size, according to the wrist. A closed bangle, with no opening, must first pass over the hand. A chain or a cord, finally, is measured by its total length.

For our clasped rigid bracelets, the size is your wrist circumference, in centimetres. A 16 cm wrist wears a size 16: the necessary ease is already built into the piece. Nothing to add, nothing to calculate.

Clasped rigid bracelet

Measure your wrist just below the bone, without tightening the tape. The bracelet’s size corresponds directly to this measurement: this is the fit we recommend. The size above gives a looser fit, where the model’s geometry allows it. Between two measurements, choose the larger.

Open rigid bangle

Measure your wrist just below the bone as well. An open bangle is chosen by size, from XS to XL, according to your wrist circumference. Its opening lets you slip it over the side of the wrist; it is not meant to be spread or tightened with each wear.

SizeWrist circumference
XS13 to 14.4 cm
S14.4 to 15.8 cm
M15.8 to 17.2 cm
L17.2 to 18.6 cm
XL18.6 to 20 cm

For a looser fit, choose the size above. Outside these ranges, our workshops make your bangle to measure.

Closed rigid bangle, with no opening

Measuring the wrist is not enough. Bring the thumb towards the little finger, fingers together, then measure around the hand at its widest point. This circumference determines the minimum inner diameter that lets the bangle slip on. The size is therefore chosen by inner diameter, not by the wrist measurement alone.

Chain, supple bracelet or cord

The size corresponds to the total length of the closed bracelet: your wrist circumference, plus the ease of the fit you want.

Close to the wrist Wrist + 0.5 cm

The bracelet stays in place and turns little.

Natural fit Wrist + 1 cm

The most versatile ease: the bracelet follows movement without sliding down onto the hand.

Loose fit Wrist + 1.5 to 2 cm

The bracelet is mobile and slides towards the hand. The charm of chains and cords.

An adjustable cord suits you when your wrist circumference falls within its adjustment range.

  1. Cut out the tape and slit the black slot.
  2. For a bracelet with an opening, measure the wrist just below the bone, without compressing the skin.
  3. For a closed bangle, measure instead the widest part of the hand, thumb folded in.
  4. Read the value in centimetres, then apply the rule that matches the construction of the piece.

Between two sizes, choose the larger. For a particular measurement, our workshops can adjust or make the piece to your measurements.

Tape measure · 12 to 22 cm
ORIGINE PARIS cm 1213141516171819202122

Our rings and wedding bands are offered from size 49 to size 58, in half sizes. The Daisy signet ring, also worn on the little finger, is offered from size 42 to size 58. Beyond these ranges, as for any bracelet or bangle outside standard lengths, our workshops make your piece to measure.

Book an appointment